Modified Burgers-Reimschuessel model for moisture-sensitive polymers

Viscoelastic properties of moisture-sensitive polymers can be significantly affected by moisture in the ambient environment, resulting in drastic changes in the properties as the absorbed moisture content increases. In this article, a simple yet important modification to the Reimschuessel model is introduced by considering both plasticization and anti-plasticization induced by water molecules. The proposed model is validated against the results of four different polymers obtained by Onogi et al., which demonstrates its capability of describing the available data. This model can be used to estimate the performance and service life of products produced using moisture-sensitive polymers. It also reveals that small amounts of diffused moisture might have a stiffening effect on the mechanical properties of hydrophilic polymers.     

An experimental investigation into non-linear wave loading on horizontal axis tidal turbines

Tidal turbines are subject to large hydrodynamic loads from combinations of currents and waves, which contribute significantly to fatigue, extreme loading and power flow requirements. Physical model testing enables these loads and power fluctuations to be assessed and understood in a controlled and repeatable environment. In this work, a 1:15 scale tidal turbine model is utilised to further the fundamental understanding of the influence of waves on tidal turbines. A wide range of regular waves are generated in both following-current and opposing-current conditions. Wave frequencies range from 0.31 Hz to 0.55 Hz & wave heights from 0.025 m to 0.37 m in a fixed 0.81 m/s current velocity. Waves are selected and programmed specifically to facilitate frequency domain analysis, and techniques are employed to isolate the effect of non-linear waves on turbine power and thrust.Results demonstrate that wave action induces large variations in turbine power and thrust compared to current only conditions. For the range of conditions tested, peak values of thrust and power exceed current-only values by between 7%–65% and 13%–160% respectively. These wave-induced fluctuations are shown to increase with wave amplitude and decrease with wave frequency. Following wave conditions exhibit greater variations than opposing for waves with the same wave height and frequency due to the lower associated wavenumbers.A model is developed and presented to aid the understanding of the high-order harmonic response of the turbine to waves, which is further demonstrated using steady state coefficients under assumptions of pseudo-stationarity. This approach is proven to be effective at estimating wave-induced power and thrust fluctuations for the combinations of waves, currents and turbine state tested. The outcome of which shows promise as a rapid design tool that can evaluate the effect of site-specific wave–current conditions on turbine performance.     

A STUDY OF LOW CYCLE FATIGUE PROPERTIES OF MATERIALS BASED ON THE FUNNEL-SHEET SPECIMENS1)

根据能量等效方法,针对漏斗薄片试样,提出了关联Ramberg-Osgood 幂律参数、试样几何参数的载荷-位移半解析统一模型。采用有限元数值模拟,正、反向验证了该模型的有效性。在此基础上,提出了通过漏斗薄片试样低循环试验实现材料低周疲劳性能的预测方法。基于薄片试样低循环试验数据,完成了SS316L, N18及SAPH440 三种材料的低周疲劳性能预测,预测结果与标准试样试验结果具有良好的一致性。并利用该方法完成了N18与SAPH在不同温度条件下的低周疲劳性能预测。     

一种考虑界面相物性影响的界面单元法

界面是由复杂的界面相简化而成的,界面破坏实际是界面相材料的破坏。数值计算为了方便,如经典模型和内聚力模型等,都把很薄的界面相作无厚度化处理。导致只能考虑界面的面力,而无法考虑界面相内的应力(平行于界面方向的应力)。使界面失效准则先天性地排除了界面相内部应力的影响,从界面相材料失效机理的角度来看这是不够严谨的。本文将界面相材料等效为一种弹性连续体,由界面本构关系推导得到了一种新的界面单元。该单元具有界面参数易确定、对界面相物性可以进行等效描述等优点。通过商用有限元软件ABAQUS和用户子程序UEL实现了数值分析,并与直接物理模型的数值模拟结果进行对比,证明了本方法的简便及准确性。通过对不同界面相厚度结构的进一步分析,探讨了本文方法的可行范围。     

Assortment optimization under the multinomial logit model with product synergies

In synergistic assortment optimization, a product’s attractiveness changes as a function of which other products are offered. We represent synergy structure graphically. Vertices denote products. An edge denotes synergy between two products, which increases their attractiveness when both are offered. Finding an assortment to maximize retailer’s expected profit is NP-hard in general. We present efficient algorithms when the graph is a path, a tree, or has low treewidth. We give a linear program to recover the optimal assortment for paths.     

A mathematical model for the 3d location estimation of 2D echocardiography data

The recovery of 3D left ventricle(LV) shape using 2D echocardiography is very attractable topic in the field of ultrasound imaging. In this paper, we propose a mathematical model to determine the 3D position of LV contours extracted from multiple 2D echocardiography images. We formulate the proposed model as a non-convex constrained minimization problem. To solve it, we propose a proximal alternating minimization algorithm with a solver OPTI for quadratically constrained quadratic program. For validating the proposed model, numerical experiments are performed with real ultrasound data. The experimental results show that the proposed model is promising and available for real echocardiography data.     

我国A股房地产板块羊群效应研究

借助CSAD模型、马尔科夫转换模型和GARCH模型的研究结果表明我国A股房地产板块存在明显的羊群效应且存在如下特点:非对称性,扩张期较衰退期更为显著;规模差异性,大盘股较中小盘股更为显著;房地产调控政策影响的非对称性,紧缩政策较之宽松政策会诱发更加明显的羊群效应;产业链传染性,上下游行业中的羊群效应产生影响.非系统性风险和系统性风险都对A股房地产板块羊群效应产生了促进影响,且系统性风险的影响较大.     

不确定环境下基于时间、费用及鲁棒性权衡的多目标项目调度优化

项目调度中的时间和费用是两个重要的指标,而在不确定环境下进度计划的鲁棒性则是保证项目平稳实施的关键。本文研究不确定环境下的多目标项目调度优化问题,以优化项目的工期、鲁棒值和成本为目标安排各活动的开始时间。基于此,作者构建多目标项目调度优化模型,将模型分解为三个子模型分析目标间的权衡关系,然后设计非劣排序遗传算法进行求解,应用精英保留策略和基于子模型权衡关系的优化策略优化算法,进行算法测试和算例参数敏感性分析。最后,应用上述方法研究一个项目实例,计算得到非劣解集,实例的敏感性分析结果进一步验证了三个目标间的权衡关系,据此提出资源的有效利用策略。本文的研究可以为多目标项目调度制定进度计划提供定量化决策支持。